686845ff31 | ||
---|---|---|
.vscode | ||
CMSIS | ||
build | ||
cmake | ||
n32g430_std_periph_driver | ||
source | ||
.clang-format | ||
.gitignore | ||
CMakeLists.txt | ||
README.md | ||
n32g430_flash.ld | ||
project.cmake | ||
startup_n32g430_gcc.s |
README.md
1、功能说明
此例程展示了作为从机使用双地址模式收发数据。
2、使用环境
软件开发环境: IDE工具:KEIL MDK-ARM 5.34.0.0 IAR EWARM 8.50.1
硬件环境:
开发板:N32G430C8L7-STB V1.0
3、使用说明
1、主时钟:128MHz
2、I2C 配置:
SCL --> PB6
SDA --> PB7
CLOCK:100KHz
3、UART1配置:
TX --> PA9
RX --> PA10
波特率:115200
4、测试步骤与现象
a,跳线连接主机I2C
b,编译下载代码复位运行
c,从串口看打印信息,验证结果
4、注意事项 SCL及SDA必须接上拉
-
Function description
This routine demonstrates using dual address mode to send and receive data as a slave.
-
Use environment
Software development environment: IDE tool: KEIL MDK-ARM V5.34.0.0 IAR EWARM 8.50.1
Hardware environment: Development board: N32G430C8L7-STB V1.0
-
Instructions for use
-
Main clock: 128MHz
-
I2C1 configuration: SCL --> PB6 SDA --> PB7 CLOCK: 100KHz
-
USART1 configuration: TX --> PA9 RX --> PA10 Baud rate: 115200
-
Test steps and phenomena a, jumper to connect the host I2C1 b, compile and download the code to reset and run c, see the print information from the serial port, and verify the result
-
-
Matters needing attention SCL and SDA must be pulled up