/* A brief description of the engineering function */
This routine configures and demonstrates reading and writing directly to FLASH
2. Use environment
Software development environment: KEIL MDK-ARM V5.34.0.0
IAR EWARM 8.50.1
Hardware environment: Developed based on the evaluation board N32G430C8L7-STB V1.0
3. Instructions for use
/* Describe the related module configuration method; For example: clock, I/O, etc. */
SystemClock: 128 MHZ
USART: TX-PA9, RX-PA10, baud rate 115200
/* Describes the test steps and symptoms of Demo */
1. Reset and run the downloaded program after compilation;
2. Check the information printed through the serial port. If the data written to the FLASH is the same as the data read from the FLASH, the test is complete.